Allied Telesis AlliedView-EMS 3.10 INSTALLATION - Manual (Page 8)

AlliedView™-EMS 3.10 INSTALLATION GUIDE Page 8 of 29
Click Next to continue.
If you choose to install the AlliedView-EMS 3.10 application only, the documentation for
the application will not be available after the installation. You will have to run the
installer again and choose the option “AlliedView-EMS Documentation” to install the
documentation.
If you choose to install the AlliedView-EMS 3.10 documentation only, you will have to
specify a folder where the documents will be installed, unless AlliedView-EMS 3.10
application is already installed. You will not have the option to integrate AlliedView-EMS
3.10 with an NMS since you will not be installing the application.
If there is a previous installation of AT-View Plus or AlliedView-EMS on your machine, a
message box will open advising you to uninstall the application first before running the
AlliedView-EMS 3.10 installer again. To uninstall AT-View Plus or AlliedView-EMS, refer
to Section 10
Uninstalling AlliedView-EMS or AT-View Plus .
5. Specify the mode or type of installation, if you want to install AlliedView-EMS 3.10 and
integrate it with an NMS or just install the AlliedView-EMS 3.10 application and/or
documentation. The selection below will depend on which network management
system is installed on your computer.
This window will not be displayed if you have chosen to install the AlliedView-EMS 3.10
documentation only, if you do not have an NMS installed on your computer, or if
SNMPc or OpenView services are running or NetView services are not running or if the
WhatsUp Engine service is not running and the WhatsUp SQL services are running.
Note - It is not advisable to have more than one network management application
installed on the same machine as conflicts may arise between or among the network
management applications installed. Such conflicts may cause the integration between
AlliedView-EMS and the selected network management application to fail.
Select “NONE” if you want to install AlliedView-EMS 3.10 as a standalone application.