Allied Telesis AT-S97 - Manual (Page 139)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
139
Note the following guidelines when modifying the commands in this
section:
ˆ Each port must have its own command line.
ˆ A port can have more than one command line.
ˆ A command line cannot exceed eighty characters.
ˆ If you delete a port’s configuration command from the file, the port
operates with the default settings.
ˆ The ID parameter specifies just the channel number and port letter.
The name of a media converter module and the temperature threshold are
controlled with the commands in the final part of a Blade Configuration
section, shown in Figure 30.
Figure 30. Blade Configuration - Module Name and Temperature
Threshold Section
The first two lines control the module’s name and temperature threshold.
The commands are a modified version of the SYSTEM SET MODULE
command, with the MYMODULE keyword substituting for the MODULE
keyword, as explained earlier in the System Configuration section. Do not
change the ID values. Though in all other cases a slot “0” designation
would indicate the management module, this is not true for these lines in
the Blade Configuration section. Here, the “0” slot designation signifies the
module itself, in this case a media converter module.
The final two lines with the IDs “0/A” and “0/B” can be ignored.
Guidelines to Editing a Master Configuration File
The following guidelines apply to editing a configuration file:
ˆ The text editor must be able to store the file as ASCII text. Do not use
special formatting codes, such as boldface or italics.
ˆ A command cannot exceed eighty characters.
ˆ Each command must start flush left against the margin.
ˆ To comment out a command so that the switch does not perform it,
precede the command with three pound symbols (#).
system set mymodule id=0/0 name="none"
system set mymodule id=0/0 temperature-threshold=60
system set mymodule id=0/a temperature-threshold=60
system set mymodule id=0/b temperature-threshold=60