Allied Telesis SwitchBlade Chassis and Fan Tray - Manual (Page 10)

10 SwitchBlade Chassis and Fan Tray
C613-04029-01 REV C
7. Secure the fan tray
Rotate the ejector levers until both locking mechanisms engage their holes
in the chassis.
8. Install the fan tray faceplate
Place the faceplate over the fan tray so that the plate’s two mounting
screws line up with the threaded holes on the fan tray (see Figure 6 on
page -10).
Tighten the mounting screws.
Figure 6: Installing fan tray faceplate.
9. Check the fan tray’s operation
If the chassis is receiving power and the stand-by switch is in the Run
position, you should hear the fans running and feel air movement across
the chassis vents.
10. Attach the cable manager
If you detached a cable manager to install the fan tray, re-attach it now.
A cable manager for the AT-SB4108 (SwitchBlade 8) can be purchased
separately, contact your authorised Allied Telesyn distributor or reseller for
more information.