Allied Telesis AT-S81 - Manual (Page 113)

AT-S81 Management Software User’s Guide
Section I: Using the Menus Interface 113
Adding or
Removing a
Tagged Port in a
VLAN
To add a tagged port to the VLAN, perform the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 15 on
page 75.
2. From the Advanced Switch Configuration Menu, type V to select VLAN
Management.
The VLAN Management Menu is shown in Figure 21 on page 105.
3. To add a tagged port, type A for Add Member and press Enter.
The following prompt is displayed:
Add member->Enter port number >
4. Enter the number of the port and press Enter. You can add more than
one port at a time. You can specify the ports individually (i.e., 2,5,11),
as a range (i.e., 4-7), or both (i.e., 2,5,11-15).
5. To remove a tagged port, type R for Remove Member and press
Enter.
The following prompt is displayed:
Delete number -> Enter port number >
6. Enter the number of the tagged port you want to remove and press
Enter. You can remove more than one port at a time. You can specify
the ports individually (i.e., 2,5,11), as a range (i.e., 4-7), or both (i.e.,
2,5,11-15).