Allied Telesis AT-S84 - Manual (Page 257)

AT-S84 Management Software User’s Guide
Section II: Web Browser Interface 257
The name can contain up to 32 characters including spaces but not
including special characters such as asterisks (*) or exclamation points
(!).
If the VLAN will be unique in you network, then the name should be
unique as well.
If the VLAN will be part of a larger VLAN that spans multiple switches,
then the name for the VLAN should be the same on each switch where
nodes of the VLAN are connected.
4. In the Static Tagged row, click the buttons of those ports on the switch
that are to be tagged or untagged members of the new VLAN.
While you might assume that the Static Tagged row is only used to
specify tagged ports of the VLAN, you should use it to specify the
untagged ports of a new VLAN as well.
5. Click Apply to create the new VLAN.
The switch creates the VLAN. However, the page does not change. It
continues to display the VLAN just created.
6. To create another new VLAN, click Clear or repeat this procedure.
7. If the new VLAN contains untagged ports, perform the next procedure,
“Configuring the PVID of Untagged Ports” on page 258, to change the
PVID of the untagged ports to match the virtual LAN’s VID.