Allied Telesis AT-S82 - Manual (Page 23)

AT-S82 Management Software User’s Guide
23
Rebooting the Switch
This procedure reboots the switch and reloads the AT-S82 management
software from flash memory. You might reboot the device if you believe it
is experiencing a problem. Rebooting the device does not change any of
the device’s parameter settings.
Caution
The switch does not forward network traffic during the reboot
process. Some network traffic may be lost.
To reboot the switch, perform the following procedure:
1. From the main menu, select Reboot.
The Reboot page is shown in Figure 6.
Figure 6. Reboot Page
2. Click Reboot.
The switch immediately begins to reload the AT-S82 management
software. This process takes approximately one minute to complete.
You can not manage the device during the reboot. After the reboot is
finished, you can log in again if you want to continue to manage the
switch.