AMX NetLinx ZigBee Compatible Gateway and Repeater NXR-ZGW/-ZRP - Manual (Page 7)

Overview
1 NXR-ZGW/-ZRP
Overview
The NXR-ZGW (FG5791-01) is an Ethernet to ZigBee wireless gateway. The NXR-ZGW features a
10BaseT, half duplex Ethernet port capable of Power over Ethernet (PoE), 16 Mbytes of Flash, 16
Mbytes of SDRAM, and a ZigBee module, and is controlled via a web server interface. The NXR-ZRP
(FG5791-02) is a ZigBee wireless repeater that features 16 Mbytes of Flash, 16 Mbytes of SDRAM, and
a ZigBee module.
NXR-ZGW Specifications
The following table outlines the specifications for the NXR-ZGW.
NXR-ZGW (FG5791-01) Specifications
Dimensions (HWD): • .906 x 2.500 x 3.424 (23.01 mm x 63.50 mm x 86.96 mm), depth does not
include antenna
Weight: • 0.35 lbs (158.75g)
Power: 10.5 - 18 VDC; 13.5 (nominal operation voltage), or
Power over Ethernet (PoE) Class 2
Memory: • 16 Mbytes of Flash
• 16 Mbytes of SDRAM
Radio Specifications:
Frequency IEEE 802.15.4
Operating channels • 11 - 26
Modulation technique • DSS
Output power • Region/country specific
Coverage area 165 feet (50.2m)
Firmware/Software
Specifications:
Management • Built-in browser-based management with User Name/Password
authentication
IP configuration • Static IP or DHCP client (default is static, 192.168.1.140)
Communications • The NXR-ZGW communicates with a Netlinx master over TCP/IP
encapsulating the ICSP protocol via a physical Ethernet connection. The
ICSP device number can be set via the browser-based management system.
Front Components:
LEDs • PWR/STATUS - A green LED that blinks to indicate the device is installed
and communicating properly. Power ON, but no master connection, is
indicated with a solid light; Power OFF is indicated with no light.
• LAN - A green LED indicates an Ethernet connection is established. The LED
blinks to indicate both sending and receiving information via Ethernet.
• RF - The LED is solid when end devices are connected; end devices not
connected is indicated with no LED light; the LED blinks to indicate activity.
Antenna Mount A reverse SMA connection that supports a 2.4GHz antenna.
ID Button When used in conjunction with NetLinx Studio, sets the device and system
numbers for the NXR-ZGW. Press and hold for approximately 30 seconds to
return the NXR-ZGW to factory default settings.