Allied Telesis ALLIEDVIEW-UM 1.6 - Manual (Page 92)

Allied Telesis AlliedView-UM 1.6
User's Guide
PN 613-000381 Rev B
Page 92 of 129
13.1 CREATING A HELP FILE UPDATE PROFILE
Software Selection
1. Help Filename - Specify the Help file to use.
2. Upload Options - Choose one of the following options:
ƒ Upload - Uploads the Help file only.
ƒ Upload and set - Uploads and sets the Help file.
3. File Deletion Options
ƒ Delete old help files if memory space is insufficient checkbox - If the devices to be
upgraded have limited memory space (e.g. routers), there might be a need to delete the existing
Help files in order to accommodate the new Help file. If a Help file cannot be downloaded due to
space limitations and this option is checked, AlliedView-UM will delete any Help files residing in the
device except for the currently set Help file. If unchecked, and there is not enough space to
accommodate the new Help file, AlliedView-UM will fail the operation.
ƒ Delete currently used help file if memory space is insufficient checkbox - This option will
only be enabled if the above option is checked. Otherwise, it will be grayed out. When this option is
checked, AlliedView-UM will also delete the currently set Help file if there is still insufficient space in
the device after deleting the other Help files.
Upload Parameters
1. Server - This is the address for the server that contains the Help file. If the server is a TFTP server, the
server address should be specified as an IP address. If the server is an HTTP server, the server address
should be specified as a URL.
2. Destination - This sets the location where the new Help file will be stored. This can be set to FLASH or
NVS.
3. Protocol - This specifies the protocol that the server supports. This can be set to HTTP or TFTP.