Allied Telesis AT-S70 - Manual (Page 113)

AT-S70 Management Software User’s Guide
113
Downloading
Files from a
Remote
Management
Session
Guidelines
This section contains the procedure for downloading a new AT-S70
software image file or configuration file onto a chassis from a remote
management session. The remote unit can be a chassis where you
started a Telnet management session.
Here are guidelines that apply to downloading files from a local
management session:
ˆ You must use TFTP to remotely download a file.
ˆ There must be a node on your network that contains the TFTP server
software. The AT-S70 image file or configuration file to be downloaded
must be stored on the computer or a terminal connected to the console
port on the AT-CV5M01 CPM card.
ˆ You must start the TFTP server before you begin the download
procedure.
ˆ The chassis where you are downloading the file must have an IP
address and subnet mask.
Downloading
Files using
Hilgraeve
HyperTerminal
To perform the file transfer using the Hilgraeve HyperTerminal.
1. From the HyperTerminal main window, select the Transfer menu.
2. Select Send File from the pull-down menu, as shown in Figure 42.
Figure 42. HyperTerminal Window
The Send File window, as shown in Figure 37, is displayed.
Figure 43. Send File Window
3. Click the Browse button to select the file to be downloaded onto the
chassis.