Allied Telesis AT-S41 - Manual (Page 97)

AT-S41 User’s Guide
97
Note
Check to make sure the VLAN Type is set to 802.1Q. 802.1Q is the
default VLAN Type. You can create tagged and untagged VLANs
only when the switch is operating in the 802.1Q mode. For
instructions on how to change the switch’s VLAN mode, see Setting
the VLAN Type on page 114.
3. From the VLAN Management Menu, select C for Create VLAN.
The VLAN Creation Menu is displayed in Figure 25.
Figure 25 VLAN Creation Menu
4. Type I to select Set VLAN ID/Index.
The following prompt is displayed:
Enter VLAN ID ->Enter VLAN ID >
5. Enter a VID for the new VLAN. The VID can be between 2 and 4094.
Press Enter.
If this VLAN will be unique in your network, then its VID must also be
unique from all other VIDs in the network.
If this VLAN will be part of a larger VLAN that spans multiple AT-
8326GB stacks, than the VID value for the VLAN should be the same
on each stack. For example, if you are creating a VLAN called Sales
that will span three AT-8326GB stacks, you must assign the Sales
VLAN on each stack the same VID value.
AT-8326GB Local Management System
Enter the character in square brackets to select option
Advanced Switch Configuration -> VLAN Creation Menu
VLAN Index :
VLAN Name :
Device Member
--------
-----------------------------------------------------
1
2
3
---------------------------- <COMMAND> -----------------------------
Set VLAN [I]D/[I]ndex [S]elect Port Member
Set VLAN [N]ame [A]pply
[Q]uit to previous menu
Command> _
Enter the character in square brackets to select option