Allied Telesis AT-LMC10ST - Manual (Page 19)

AT-LMC10SC and AT-LMC10ST Installation Guide
9
Note
Do not remove the dust cover from the fiber optic port until you are
ready to connect the fiber optic cable. Dust contamination can adversely
impact the operating performance of the port on the media converter.
2. If you are installing the media converter in an AT-MCR12 chassis, refer to
the chassis’s installation guide for instructions on how to install the unit,
then proceed to Step 5.
3. Place the media converter on a flat, secure surface (such as a desk or
table) leaving ample space around the unit for ventilation.
4. Attach the four protective rubber feet to the bottom of the media
converter, as illustrated in Figure 6.
Note
Do not attach the protective feet if you are installing the unit in
an AT-MCR12 chassis.
Figure 6 Attaching the Protective Feet
5. Plug the AC/DC power adapter into an appropriate AC power outlet and
insert the power plug into the DC receptacle located on the back of the
unit. Refer to Figure 7 on page page 10.
Note
This step does not apply if you installed the unit in an AT-MCR12 chassis.
TX RX
AT-LMC10SC ETHERNET MEDIA CONVERTER
CLASS 1
LASER PRODUCT
DO NOT ST ARE
INTO BEAM
10Base-FL 10Base -T
PWR
REC
LNK
MDI-X MDI
REC
LNK