Allied Telesis AT-PB100 Series - Manual

Electrical Safety and Emission Statement
Standards: This product meets the following standards.
RFI Emission EN55022 Class A
WARNING: In a domestic environment this product may cause radio interference in which case the user may
be required to take adequate measures.
Immunity EN55024
Electrical Safety EN60950, UL1950 (UL/cUL)
Laser EN60825
Copyright  2000 Allied Telesyn International, Corp.
All rights reserved. No part of this publication may be reproduced without prior written permission
from Allied Telesyn International, Corp.
Allied Telesyn International Corp.
960 Stewart Drive, Suite B
Sunnyvale, CA 94085 USA
Tel 1 (408) 730-0950 • Fax 1 (408) 736-0100
Visit our web site at: www.alliedtelesyn.co e
U.S. Federal Communications Commission
RADIATED ENERGY
Note: This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to
Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with this instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
Note: Modifications or changes not expressly approved of by the manufacturer or the FCC, can void your right to
operate this equipment.
Industry Canada
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le matériel brouilleur du
Canada.
Overview
The AT-PB100 Series Fast Ethernet Media Converters are hot swappable
modules designed for the PowerBlade Chassis. These media converters extend
the distance of your network by interconnecting twisted pair and fiber optic
cabling. Each module features a 100Base-TX twisted pair port with an RJ-45
connector and a maximum operating distance of 100 meters (328 feet). Each
unit also has a 100Base-FX fiber optic port with a maximum operating range
of 2 kilometers (1.2 miles) to 100 kilometers (62 miles), depending on the
model.
Related Documents
This quick install guide is an abbreviated version of the installation
procedures. For complete details on the features, functions and installation
instructions, refer to the PowerBlade Chassis Installation Guide. This guide is
available from Allied Telesyn’s web site at www.alliedtelesyn.com.
Cable Specifications
The following table lists the cable specifications for the 100Base-TX twisted
pair port on all AT-PB100 series modules.
Type of
Connector
Type of Twisted Pair Cable
Maximum
Distance
RJ-45 Unshielded/Shielded Twisted Pair Category 5 or
better 100 m (328 ft)
4 PN 613-50147-00 Rev A 010212
AT-PB100 Series
Fast Ethernet Media Converters
Quick Install Guide
For use with the PowerBlade Chassis