Allied Telesis AT-PB10 Series - Manual

Technical Specifications
Maximum Operating Temperature: 0° C to 40° C (32° F to 104° F)
Maximum Storage Temperature: -20° C to 80° C (-4° F to 176° F)
Operating Altitude: Up to 3,048 meters (10,000 feet)
Humidity: 5% to 80% (non-condensing)
EMC: FCC Class A, EN55022 Class A,
EN55024
Safety: EN60825, EN60950, UL 1950 (UL/cUL)
Electrical Safety and Emission Statement
Standards: This product meets the following standards.
RFI Emission EN55022 Class A
Warning: In a domestic environment this product may cause radio interference in which case the user may be
required to take adequate measures.
Immunity EN55024
Electrical Safety EN60950, UL 1950
Laser EN60825
Copyright  2001 Allied Telesyn International Corp.
All rights reserved. No part of this publication may be reproduced without prior written permission
from Allied Telesyn International Corp.
Allied Telesyn International Corp.
960 Stewart Drive, Suite B
Sunnyvale, CA 94085 USA
Tel 1 (408) 730-0950 • Fax 1 (408) 736-0100 • Web site: www.alliedtelesyn.co e
U.S. Federal Communications Commission
RADIATED ENERGY
Note: This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to
Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with this instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.
Note: Modifications or changes not expressly approved of by the manufacturer or the FCC, can void your right to
operate this equipment.
Industry Canada
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment
Regulations.
Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le matériel brouilleur du
Canada.
Overview
The AT-PB10 Series Fast Ethernet Media Converters are hot swappable
modules designed for the PowerBlade Chassis. These media converters extend
the distance of your network by interconnecting twisted pair cabling and fiber
optic cabling or twisted pair cabling and thinnet cabling. Each media
converter (except for the AT-PB15) features a 10Base-T twisted pair port and
a 10Base-F fiber optic port. The twisted pair port has an RJ-45 connector and
a maximum operating distance of 100 meters (328 feet). The fiber optic port
has an ST or SC connector and a maximum operating distance of 2 kilometers
(1.2 miles). These units operate at 10 Mbps and feature full-duplex operation.
The AT-PB15 features a 10Base-T twisted pair port and a 10Base2 thinnet
port. The twisted pair port has an RJ-45 connector and a maximum operating
distance of 100 meters (328 feet). The thinnet port has a BNC-type connector
and a maximum operating distance of 185 meters (606 feet). The AT-PB15
operates at 10 Mbps and features half-duplex operation only.
Related Documents
This quick install guide is an abbreviated version of the installation
procedure. For complete details on the features, functions and installation
instructions, refer to the PowerBlade Chassis Installation Guide. This guide is
available from Allied Telesyn’s web site at www.alliedtelesyn.com.
4 PN 613-50146-00 Rev B 011030
AT-PB10 Series
Fast Ethernet Media Converters
Quick Install Guide
For use with the PowerBlade Chassis