Allied Telesis AT-S39 - Manual (Page 51)

AT-S39 User’s Guide
51
Configuring
Management
Access
To configure the console timer, web access, SNMP access, and TFTP
server security features of the AT-S39 management software, perform
the following procedure:
1. From the Main Menu, type 5 to select System Config Menu.
The System Configuration Menu Figure 4 on page 44 is displayed.
2. To configure the console timer, type 3 to select Console Disconnect
Timer Interval and, when prompted, enter a value of from 1 to 60
minutes. The default value is ten minutes.
For example, if you specify 2 minutes, the AT-S39 management
software automatically ends a management session if it does not
detect any activity from the local or remote management station
after 2 minutes.
3. To configure web browser access, type 4 to select Web Server Access
and, when prompted, type E to enable web access or D to disable
web access. The default value is enabled.
For example, if you disable web access, no one will be able to
manage the switch remotely using a web browser.
4. To configure SNMP access, type 5 to select SNMP Access and, when
prompted, type E to enable SNMP management access or D to
disable it. The default value is disabled.
For example, if you disable SNMP access, no one will be able to
manage the switch remotely using an SNMP management
program.
5. After you have made the desired changes, type S to select Save
Configuration Changes.
Your changes are immediately activated on the switch.