Hubbardton Forge 205772L - Manual

Installation Instructions
B225
Forged Leaf and Stem Sconce 20-5770L & 20-5770R Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 26776
Caution: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all applications. If
installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
Please Note: The hardware provided is intended for use in wood frame construction and may not be suitable for all
applications. If installing in non-wood frame applications, please consult a qualified builder to determine and obtain the
appropriate fasteners.
To Install Fixture (Figure 1)
Component Parts
A Cross Head Machine Screws (2) (Provided)
B Back plate
C Crossbar
D Ground
Screw
Caution: Be sure power is off at the main
breaker box prior to installation.
1. Carefully unpack the fixture from the
carton.
2. Using two machine screws (not
provided), fasten the crossbar (C) to the
electric box (see illustration), making
sure that fixture mounting holes are
level.
Note: A new electric box comes with
screws. When replacing a fixture, retain
the existing screws for use with the new
fixture.
3. Using suitable wire connectors (not
provided) connect fixture wires to
supply wires (white to white and black
to black). If the fixture is wired with
twin lead lamp cord, connect white to
ribbed side of the fixtures cord, black to
smooth side. Run a pigtail lead from
crossbar ground screw (D) to the
junction box and connect all ground
wires (bare copper or green to bare copper or green).
Caution: Make sure wire connectors are twisted on securely, and no bare wire is exposed.
4. Once wires are connected securely line up holes in back plate with the threaded holes in the crossbar. Thread in
the two cross head machine screws provided until back plate is secured against wall.
5. Install light bulb(s) (not provided).
6. Install glass (see instructions below).
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
This illustration represents a typical
fixture and may not match every style.
Figure 1