Hubbardton Forge 205772FL - Manual

Installation Instructions
B233
Forged Leaf and Stem Sconce 20-5770FL & 20-5770FR Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 26935
Caution: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all applications. If
installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
Please Note: The hardware provided is intended for use in wood frame construction and may not be suitable for all
applications. If installing in non-wood frame applications, please consult a qualified builder to determine and obtain the
appropriate fasteners.
To Install Fixture (Figure 1)
Component Parts
A Cross Head Machine Screws (2) (Provided)
B Back
plate
C Crossbar
D Ground
Screw
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the crossbar (C) to the electric box (see illustration), making
sure that fixture mounting holes are level. Note: A new electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture.
3. Using suitable wire connectors (not provided)
connect fixture wires to supply wires (white to
white and black to black). If the fixture is
wired with twin lead lamp cord, connect white
to ribbed side of the fixtures cord, black to
smooth side. Run a pigtail lead from crossbar
ground screw (D) to the junction box and
connect all ground wires (bare copper or green
to bare copper or green).
Caution: Make sure wire connectors are
twisted on securely, and no bare wire is
exposed.
4. Once wires are connected securely line up
holes in back plate with the threaded holes in
the crossbar. Thread in the two cross head
machine screws provided until back plate is
secured against wall. Make sure no wires are
pinched between back plate and wall.
5. Install light bulb (not provided).
6. Install acrylic (see instructions below).
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Figure 1