Hubbardton Forge 205772 - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved. 28861
Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Caution: This fixture is designed to be mounted on a standard wall
surface and may not be suitable for all applications. If installing in a
non-wood frame application, we recommend consulting a qualified
builder or electrician.
Please Note: The hardware provided is intended for use in wood frame
construction and may not be suitable for all applications. If installing
in non-wood frame applications, please consult a qualified builder to
determine and obtain the appropriate fasteners.
To Install Fixture (Figure 1)
Component Parts
A Cross Head Machine Screws (2) (Provided)
B Back plate
C Crossbar
D Ground Screw
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the
crossbar (C) to the electric box (see illustration), making
sure that fixture mounting holes are level.
Note: A new electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture.
3. Using suitable wire connectors (not provided) connect 2 sets
of fixture wires to supply wires (whites to whites and blacks
to blacks). Run a pigtail lead from crossbar ground screw (D)
to the junction box and connect all ground wires
(bare copper or green to bare copper or green).
CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON
SECURELY, AND NO BARE WIRE IS EXPOSED.
4. Once wires are connected securely line up holes in back
plate with the threaded holes in the crossbar. Thread in the
two cross head machine screws provided until back plate is
secured against wall.
5. Install glass (see instructions below).
B300
Forged Leaf and Stem Sconce, LED, 205772DL & 205772DR Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
(Figure 1)
D
(Continued)
C
A
B