Hubbardton Forge 206730D - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved. 28862
Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Please Note: This fixture is designed to be mounted on a standard wall
surface and may not be suitable for all applications. If installing in a non-
wood frame application, we recommend consulting a qualified builder
or electrician.
To Mount Fixture to Wall & Install Glass (Figure 1)
Component Parts
A Glass F Ground Screw
B Top Adjusting Nut G Mounting Screw (2)
C Bent Bracket (top) H Bottom Adjusting Nut
D Textured Bar I Bent Bracket (bottom)
E Crossbar J Support Bar
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the
crossbar (E) to the electric box making sure that fixture
mounting holes are level.
Note: A new electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture.
3. Hold the fixture assembly close to the wall and using
suitable wire connectors, not provided, connect fixture wires
to supply (whites to whites and blacks to blacks). Run a
pigtail lead from crossbar ground screw (F) to the junction
box and connect all ground wires (bare copper or green to
bare copper or green).
CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON
SECURELY, AND NO BARE WIRE IS EXPOSED.
4. Push fixture assembly firmly to wall, making sure that no
wires are pinched between fixture back and wall. Fasten
fixture assembly to Crossbar (E) with mounting screws (G)
until the fixture is tight against the wall.
5. Orient the two bent brackets (C & I) to a horizontal position.
B301
Forged Vertical Bar, LED 206729D & 206730D Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
(Figure 1)
A
B
C
D
E
(Continued)
F
G
H
I
J