Hubbardton Forge 138650 - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved. 30852
Assembly & Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Note: Support Cable also acts as Low Voltage Supply Cable.
To Install to Ceiling (Figures 1-5)
Component Parts
A Ceiling Bracket
B Lag Screw (4)
C Canopy
D Canopy Support Cable
E #8 Screw
F Support/supply Cable (3)
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
1. Carefully unpack the fixture from the carton. Put the ceiling
bracket (A) and canopy (C) together, making sure the canopy
mounting holes match up with the ceiling bracket threaded
standoffs. Orient them to achieve desired wire location.
Note: Flat head screws (H) will need to be removed from
ceiling bracket (A) prior to installation of the canopy (C). The screws
are shipped installed. Remove screws and retain for step 13.
2. Place insulating barrier (L) between ceiling bracket and
ceiling and align holes.
3. Using the four lag screws (B) attach ceiling bracket (A) to a
structural member in the ceiling, centering the crossbar over
the outlet box (Figure 1). Lag screws have been supplied
with your fixture; however, different materials and/
or construction methods may require different fasteners. If
in doubt, contact a qualified electrician. Do not
attach crossbar directly to outlet box.
4. Attach canopy support cable (D) to mounting bracket using
a #8 screw (E). Temporarily suspend canopy using
cable (Figure 2). #8 screw (E) ships installed, it will need to
be removed prior to installation of the support cable (D).
CAUTION: THE CABLE IS INTENDED TO TEMPORARILY SUSPEND THE
CANOPY TO HELP WITH FIXTURE INSTALLATION.
A365
Bento LED Pendant 138650D Page 1 of 6
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Continued)
A
G Cable Gripper (3)
H Flat Head Screws (2)
I Canopy Nipple
J Canopy Cover
K Cap
L Insulating Barrier
L
(Figure 2)
D
E
C
A
B
H