Hubbardton Forge 161040 - Manual (Page 2)

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved.
28298 C
Installation Instructions
To Install the Canopy (Figures 1 & 2)
(Continued)
CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON
SECURELY, AND NO BARE WIRE IS EXPOSED.
7. Raise canopy (D) and fixture (F) close to ceiling. Align holes
in canopy (D) with holes in crossbar (A) and secure with (2)
#8 screws (E). If fixture needs to be lowered to achieve
desired height, push up on canopy gripper (G) and gently
pull down on supply/support cable (H).
Note: Excessive movement of cable through the gripper could
cause cable to fray slightly. Adjustment is for initial installation only.
Repeated adjustment is not recommended.
To Install Glass (Figure 3)
Component Parts
F Fixture
I Glass
J Screws
1. Install bulb (not included). Be careful not to touch bulb with
bare hands; oil from the hands will dramatically reduce bulb
life.
2. Loosen the four screws (J). It is not necessary to remove
them from the fixture.
3. Raise glass (I) until groove is aligned with screws (J).
4. Tighten the four screws (J) equal amounts until snug with
glass (I). Be careful not to over tighten.
5. Restore electricity at main breaker.
A330
Link Low Voltage Pendant 161040 Page 2 of 2
I
F
(Figure 3)
J