Hubbardton Forge 161025 - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved. 27971 B
Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
To Install the Canopy (Figures 1,2 & 3)
Component Parts
A 8-32 Screw (2)
B Top Assembly
C Bottom Assembly
D Crossbar
E Ground Screw
F Cupped Washer
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
1. Carefully unpack the fixture from the carton.
2. Remove two 8-32 screws (A) from top assembly (B) to sepa-
rate from bottom assembly (C). Place bottom assembly (C)
and two 8-32 screws (A) to the side for later use. (Figure 1)
3. Using two machine screws (not provided), fasten the cross-
bar (D) to the electric box. Crossbar is shipped attached to
canopy.
4. Note: A new electric box comes with screws. When replacing
a fixture retain the existing screws for use with the
new fixture.
5. Height of fixture can be set before attaching the fixture to
the ceiling. Remove screws w/lock washers (R) and canopy
plate (Q) from canopy (G). If height is going to stay at max
length or just a slight height adjustment is needed it may not
be necessary to remove the canopy plate.
Note: Fixture is shipped at max height.
6. Push supply/support cable (J) into canopy gripper (I) until
desired height is reached.
7. Coil supply/support cable (J) in canopy (G) and place
canopy plate (Q) in canopy (G). Install screws w/lock
washers (R) to secure plate.
CAUTION: BE SURE NOT TO PINCH THE SUPPLY/SUPPORT CABLE IN
BETWEEN THE CANOPY (G) AND THE CANOPY PLATE (Q).
A321
Airis Low Voltage Pendants 161020 & 161025 Page 1 of 4
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 2)
Q
R
I
(Continued)
G
J
G Canopy
H #8 Screws
I Canopy Gripper
J Supply/Support Cable
Q Canopy Plate
R Screws w/Lock Washers C
B
A
(Figure 1)