Hubbardton Forge 205965 - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved. 30719
Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
B317
Cavo Glass Sconce Vintage Platinum 205965 Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Continued)
A
B
C
Please Note: This fixture is designed to be mounted on a standard wall
surface and may not be suitable for all applications. If installing in a non-
wood frame application, we recommend consulting a qualified builder
or electrician.
Prepare Fixture for Mounting (Figure 1)
Component Parts
A Retaining Ring
B Socket Spacer
C Fixture
1. Carefully unpack the fixture from the carton.
2. Retaining Ring (A) and Socket Spacer (B) are shipped
installed. To separate, unscrew Retaining Ring. Save parts
for later use. (Figure 1)
To Mount Fixture to Wall
(Figure 2)
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
Component Parts
D Mounting Bracket
E Machine Screws (not included)
F #8 Black Screws (4)
G Ground Screw
H Cupped Washer
1. Thread the wires in the electrical box through the hole in the
mounting bracket (D) while moving the bracket into position.
Attach to electrical box with machine screws (E).
2. Hold the fixture (C) close to the mounting bracket (D) and
using suitable wire connectors (not provided) connect fixture
wires to supply wires (white to white and black to black). Run
a pigtail lead from the ground screw (G) and cupped washer
(H) to the electrical box and connect all ground wires
(bare copper or green to bare copper or green). Install
ground screw (G) and cupped washer (H) as shown.
CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON
SECURELY, AND NO BARE WIRE IS EXPOSED.
(Figure 1)
(Figure 2)
D
C
E
F
H
E
G