Hubbardton Forge 207693 - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved. 30423
Assembly & Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Please Note: This fixture is designed to be mounted on a standard wall
surface and may not be suitable for all applications. If installing in a non-
wood frame application, we recommend consulting a qualified builder
or electrician.
After installation, extra hardware and accessories may be left due to kits
being used on multiple products.
Component Parts
A Fixture Front
B Fixture Back
C Thumb Screws (2)
D Wall Mounting Bracket
E Anchors (2)
F #10 Screws (2)
To Mount Fixture to Wall (Figures 1 & 2)
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
1. Carefully unpack the fixture from the carton.
2. Fixture front (A) and back (B) are shipped installed. To
separate, remove thumb screws (C), and pull apart. Save
parts for later use. (Figure 1)
3. Remove short #8 black screw (J) from electric box cover
(G) and save for later use. Attach electric box cover (G) to
wall mounting bracket (D) using #8 black screw (J). With a
pencil, mark the location of all mounting holes in the
wall mount bracket (D) on the wall behind.
4. Drill 1/4" holes in the locations marked on the wall. For holes
using anchors, place the tapered end of the anchors (E)
into the holes and gently tap them flush to the wall using a
light weight hammer.
5. Thread the wires in the electrical box through the hole in the
wall mounting bracket (D) while moving the bracket
into position. Using the 1" #10 screws (F), screw the bracket
securely to the wall. Be careful not to over-tighten or strip
the anchors.
B310
Oceanus Sconce Single 207693 Page 1 of 3
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Continued)
C
B
A
G Electric Box Cover
H Cupped Washer
I Ground Screw
J Short #8 Black Screw
P Long #8 Black Screws (2)