Hubbardton Forge 207697 - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved. 30321
Assembly & Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Please Note: This fixture is designed to be mounted on a
standard wall surface and may not be suitable for all ap-
plications. If installing in a non-wood frame application, we
recommend consulting a qualified builder or electrician.
Please Note: After installation, extra hardware and accessories may be
left due to kits being used on multiple products.
Component Parts
A Fixture Front
B Fixture Back
C Thumb Screws (2)
D Wall Mounting Bracket
E Anchors (4)
F #10 Screws (4)
G Electric Box Cover
H Cupped Washer
I Ground Screw
J Short #8 Black Screw
P Long #8 Black Screws (4)
To Mount Fixture to Wall (Figures 1 & 2)
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
1. Carefully unpack the fixture from the carton.
2. Fixture front (A) and back (B) are shipped installed. To
separate, remove thumb screws (C), and pull apart. Save
parts for later use. (Figure 1)
3. Remove short #8 black screw (J) from electric box cover (G)
and save for later use. Attach electric box cover (G) to wall
mounting bracket (D) using #8 black screw (J). With a
pencil, mark the location of all mounting holes in the wall
mount bracket (D) on the wall behind.
4. Drill 1/4" holes in the locations marked on the wall. For holes
using anchors, place the tapered end of the anchors (E)
into the holes and gently tap them flush to the wall using a
light weight hammer.
5. Thread the wires in the electrical box through the hole in the
wall mounting bracket (D) while moving the bracket into
position. Using the 1" #10 screws (F), screw the bracket
securely to the wall. Be careful not to over-tighten or
strip the anchors.
B308
Oceanus 3-Light Sconce 207697 Page 1 of 3
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Continued)
B
C
A