Hubbardton Forge 207815 - Manual

Installation Instructions
B291
Rook Sconce 20-7815 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 28296
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
After installation extra hardware and accessories are possible; our kits are used on multiple products and options.
To Install Fixture (Figure 1)
Component Parts
A Cross Bar
B Threaded Studs (2)
C Fixture
D Knurled Balls (2)
Caution: Be sure power is off at the main breaker box
prior to installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided) attach
cross bar (A) to the electric box using inside oval
holes to orient fixture.
Note: A new electric box comes with screws.
When replacing a fixture, retain the screws for use
with the new fixture.
3. Start threaded studs (B) into appropriate holes in
crossbar (A).
4. Using suitable wire connectors (not provided),
connect the fixture wires to the supply wires,
(white to white, black to black, bare copper or
green to bare copper or green). If the fixture is
wired with twin lead lamp cord, connect the ribbed
side to white, and the smooth side to black.
Caution: Make sure wire connectors are twisted
on securely and no bare wires are exposed.
5. Carefully tuck all wires behind the fixture. Place
fixture (C) over threaded studs (B) and tighten
firmly to mounting surface using knurled balls (D).
6. See next page for bulb and glass installation.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)