Hubbardton Forge 207812 - Manual (Page 2)

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved.
30717 Rev -
Installation Instructions
To Mount Fixture to Wall (Figures 2 & 3)
(Continued)
1. Put the wall mount bracket down and drill 1/4" holes in the
locations marked on the wall. For holes using anchors,
place the tapered end of the anchors (F) into the holes and
gently tap them flush to the wall using a light weight
hammer.
2. Thread the wires in the electrical box through the center
hole in the wall mount bracket while moving the bracket into
position. Attach wall mount bracket to electrical box using
two machine screws( not provided) Using the #10
screws (J), screw the bracket securely to the wall. Be careful
not to over-tighten or strip the anchors.
3. Hold the fixture body (B) close to the wall mount bracket (A)
and using suitable wire connectors (not provided),
connect fixture wires to supply wires (white to white or
ribbed and black to black or smooth). Ground the
mounting bracket using the green ground screw (H) and
cupped washer (G) to secure a pigtail lead to the bracket
and connect all ground wires (bare copper or green to bare
copper or green).
CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON
SECURELY, AND NO BARE WIRES ARE EXPOSED.
4. Carefully tuck all wires behind the fixture assembly and in
side the wall mount bracket and place the fixture (B) firmly
onto bracket (A) and fasten with #8 pan head screw w/lock
washer (C) (Figure 3).
B315
Rook Bath Bar Sconce 207812 Page 2 of 3
B
A
(Continued)
C
(Figure 3)