Hubbardton Forge 365894 - Manual

Installation Instructions
A7
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 14011 Rev A
For Chain Hanging Fixtures
For fixtures requiring assembly, please refer to assembly instructions before installation.
Component Parts
A Lock Nut
B Nipple
C Canopy
D Loop Collar E Canopy Loop
F Ribbed Edge Wire
G Black Wire
H Bare Ground Wire
To Install
Caution: Be sure power is off at the main breaker box prior to installation
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the crossbar to the
electric box (see illustration).
Note: A new electric box comes with screws. When replacing a fixture,
retain the existing screws for use with the new fixture.
4. Thread the nipple (B) into the crossbar and secure with lock nut (A);
slide canopy (C) over nipple, and attach the canopy loop (E) to the
nipple. Adjust the nipple to proper length to ensure a snug canopy fit
before proceeding.
5. Attach one end of the chain to the fixture loop (not shown). Lace the
wire through every other link of the chain to the end. Slip wires and
chain through the collars and canopy (E, D & C). Fasten the chain to the
canopy loop, then slip wires through the loop and nipple, into the electric
box (see illustration). Make sure to provide enough slack in the wire to
ensure weight of fixture is supported by the chain.
6. Using suitable wire connectors (not provided) connect fixture wires to
supply wires (white to ribbed side of the fixture s cord, black to smooth
side or white to white and black to black). Run a pigtail lead from
crossbar ground screw to the junction box and connect all ground wires
(bare copper or green to bare copper or green).
Caution: Make sure wire
connectors are twisted on securely, and no bare wire is exposed.
7. Raise canopy to the ceiling and secure collar to canopy loop.
8. Install light bulb(s) (not provided).
9. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.