Hubbardton Forge 103040 - Manual

Installation Instructions
A211
Flora Chandelier 10-3040 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 22849 Rev A
To Install the Canopy (Figure 1)
Component Parts
A Ground Screw
B Crossbar
C Lock Nut
D Nipple E Canopy
F Canopy Loop
G Loop Collar
H Fixture Loop
Caution: Be sure power is off at the main breaker box prior to
installation
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the crossbar
(B) to the electric box (see illustration).
Note: A new electric box comes with screws. When replacing
a fixture, retain the existing screws for use with the new fixture.
3. Thread the nipple (D) into the crossbar (B) and secure with
lock nut (C); slide canopy (E) over nipple (D), and attach the
canopy loop (F) to the nipple (D). Adjust the nipple to proper
length to ensure a snug canopy fit before proceeding.
4. Attach one end of the chain to the fixture loop (H). Lace the
wire through every other link of the chain to the end. Slip wires
and chain through the collars and canopy (G, F & E). Fasten
the chain to the canopy loop (F), then slip wires through the
loop and nipple, into the electric box. Make sure to provide
enough slack in the wire to ensure weight of fixture is
supported by the chain.
5. Using suitable wire connectors (not provided) connect fixture
wires to supply wires (white to ribbed side of the fixture s cord,
black to smooth side). Run a pigtail lead from crossbar ground
screw (A) to the junction box and connect all ground wires
(bare copper or green to bare copper or green).
Caution: Make sure wire connectors are twisted on securely,
and no bare wire is exposed.
6. Raise canopy (E) to the ceiling and secure loop collar (G) to
canopy loop (F).
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)