Hubbardton Forge 103047 - Manual

Installation Instructions
A298
Flora Chandeliers 10-3045 & 103047 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 27015 Rev A
To Install the Canopy (Figure 1)
Component Parts
A Ground Screw
B Crossbar
C Lock
Nut
D Nipple
E Canopy
F Loop Collar
G Canopy Loop
H Fixture Loop
I Chain
Caution: Be sure power is off at the main breaker box
prior to installation
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten
the crossbar (B) to the electric box (see
illustration).
Note: A new electric box comes with screws.
When replacing a fixture, retain the existing
screws for use with the new fixture.
3. Thread the nipple (D) into the crossbar (B) and
secure with lock nut (C); slide canopy (E) over
nipple (D), and attach the canopy loop (G) to the
nipple (D). Adjust the nipple to proper length to
ensure a snug canopy fit before proceeding.
4. Attach one end of the chain (I) to the fixture loop
(H). Lace the wire through every other link of the
chain (I) to the end. Slip wires and chain (I)
through the collars and canopy (G, F & E). Fasten
the chain (I) to the canopy loop (G), and then slip
wires through the loop and nipple, into the electric
box. Make sure to provide enough slack in the
wire to ensure weight of fixture is supported by
the chain (I).
5. Using suitable wire connectors (not provided)
connect fixture wires to supply wires (white to
ribbed side of the fixture cord, black to smooth
side). Run a pigtail lead from crossbar ground
screw (A) to the junction box and connect all
ground wires (bare copper or green to bare
copper or green).
Caution: Make sure wire connectors are twisted on
securely, and no bare wire is exposed.
6. Raise canopy (E) to the ceiling and secure loop collar (F) to canopy loop (G).
7. Follow instructions on next page to install glass.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
This illustration represents a typical
fixture and may not match every style.