Hubbardton Forge 103049 - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved. 30868
Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
To Install the Fixture (Figure 1)
Component Parts
A Ground Screw
B Crossbar
C Lock Nut
D Nipple
E Canopy
F Loop Collar
G Canopy Loop
H Fixture Loop
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the cross
bar (B) to the electric box (see illustration).
Note: A new electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture.
3. Thread the nipple (D) into the crossbar (B) and secure with
lock nut (C); slide canopy (E) over nipple (D), and attach the
canopy loop (G) to the nipple (D). Adjust the nipple to proper
length to ensure a snug canopy fit before proceeding.
4. Attach one end of the chain (I) to the fixture loop (H). Lace
the wire through every other link of the chain (I) to the end.
Slip wires and chain (I) through the collars and canopy
(G, F & E). Fasten the chain (I) to the canopy loop (G),
and then slip wires through the loop and nipple, into the
electric box. Make sure to provide enough slack in the wire
to ensure weight of fixture is supported by the chain (I).
5. Using suitable wire connectors (not provided) connect fixture
wires to supply wires (white to ribbed side of the fixture
cord, black to smooth side). Run a pigtail lead from
crossbar ground screw (A) to the junction box and connect
all ground wires (bare copper or green to bare copper
or green).
A368
Flora Chandelier 103049 Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1) (Continued)
L
K
H
M
J
I Chain
J Socket
K Bulb (included)
L Retaining Ring
M Glass
N Retaining Ring Tool
N
I
F
G
E
C
D
A
B