Hubbardton Forge 104203 - Manual

Installation Instructions
A316
Sphere Chandelier 104201/104203 Page 1 of 1
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 27767
To Install the Canopy (Figure 1)
Component Parts
A Ground Screw
B Crossbar
C Lock Nut
D Nipple
E Canopy F Loop Collar
G Canopy Loop
H Fixture Loop
I
Chain
Caution: Be sure power is off at the main breaker box prior to
installation
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the crossbar (B)
to the electric box (see illustration).
Note: A new electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture.
3. Thread the nipple (D) into the crossbar (B) and secure with lock
nut (C); slide canopy (E) over nipple (D), and attach the canopy
loop (G) to the nipple (D). Adjust the nipple to proper length to
ensure a snug canopy fit before proceeding.
4. Attach one end of the chain (I) to the fixture loop (H). Lace the
wire through every other link of the chain (I) to the end. Slip wires
and chain (I) through the collars and canopy (G, F & E). Fasten the
chain (I) to the canopy loop (G), and then slip wires through the
loop and nipple, into the electric box. Make sure to provide enough
slack in the wire to ensure weight of fixture is supported by the
chain (I).
5. Using suitable wire connectors (not provided) connect fixture wires
to supply wires (white to ribbed side of the fixture’s cord, black to
smooth side). Run a pigtail lead from crossbar ground screw (A) to
the junction box and connect all ground wires (bare copper or green
to bare copper or green).
Caution: Make sure wire connectors are twisted on securely, and
no bare wire is exposed.
6. Raise canopy (E) to the ceiling and secure loop collar (F) to canopy
loop (G).
7. Install light bulbs (not included).
8. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 1)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.