Hubbardton Forge 104205 - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2014 Hubbardton Forge ® . All rights reserved. 30821
Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
To Complete Fixture Assembly (Figures 1 & 2)
Component Parts
A Ground Screw
B Crossbar
C Lock Nut
D Nipple
E Canopy
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the cross
bar (B) to the electric box (see illustration).
Note: A new electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture.
3. Adjust the length of threaded nipple (D) in crossbar (B) so
that canopy ring (F) will hold canopy (E) against the
ceiling with no threads showing for best appearance. When
the correct adjustment is established, tighten lock nut
(C) against crossbar (B) to hold the adjustment.
4. Attach one end of the chain (I) to the fixture loop (H). Lace
the wire through every other link of the chain (I) to the end.
Slip wires and chain (I) through the collars and canopy (F, G
& E). Fasten the chain (I) to the canopy loop (G), and then
slip wires through the nipple (D), into the electric box. Make
sure to provide enough slack in the wire to ensure weight of
fixture is supported by the chain (I).
5. Using suitable wire connectors (not provided) connect fixture
wires to supply wires (white to ribbed side of the fixture’s
cord, black to smooth side). Run a pigtail lead from crossbar
ground screw (A) to the junction box and connect all ground
wires (bare copper or green to bare copper or green).
CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON
SECURELY, AND NO BARE WIRE IS EXPOSED.
A364
Double Cirque Chandelier 104205 Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Continued)
D
A
B
F Canopy Ring
G Canopy Loop
H Fixture Loop
I Chain C
E
G
F
I
H