Hubbardton Forge 131234 - Manual

Installation Instructions
A78
For Almost Infinity Pendant with Duet Shades 13-1224 & 13-1234 Page 1of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 19390
To Assemble Fixture
(Figures 1 & 2)
Components
A Canopy
B Clutch
(2)
C Clutch sleeve (2)
D Set
screw (2)
E Canopy pipe (2)
F Fixture pipe (2)
1. Carefully unpack the fixture from the carton.
2. Thread the wires from the fixture pipe (F) into and through the
canopy pipe (E) up through the canopy (A). Depending on the
fixture, the canopy pipe may be the larger or the smaller
diameter of the two.
3. Unscrew the clutch (B) from the larger diameter pipe (either E
or F); slide it across the wires and onto the smaller diameter
pipe (either E or F). Follow this with the clutch sleeve (C), so it
nests in the clutch (B).Slide the smaller pipe (E or F) as far as
necessary to give you the total length of the fixture which you
desire. Be careful not to scratch the pipe surfaces and to pull
excess wire up through the canopy (A). There must be a
minimum 1-1/2" of inner pipe inside the outer pipe. Hand-
tighten the clutch to temporarily hold this adjustment. At this
point the adjustment is not securely fastened; do not depend
on it to hold the fixture.
Important: To ensure full connection strength, be sure the
tapered end of the plastic clutch sleeve is oriented toward the
clutch when assembled and securely tighten set screw.
See Figure 3.
4. Stop. Please see installation instructions below.
5. Once the fixture is fastened to the ceiling, tighten the set screw
(D) firmly with hex wrench provided. Only after the set screw
(D) is tight should you install the glass.
Note: Fixtures with more than one set of pipes will need to be
leveled. Leave one clutch firmly locked with the set screw
tightened. Loosen the other clutch. Raise or lower the pipe to
obtain plum and level and then tighten the clutch and set screw.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Figure 2)