Hubbardton Forge 132200 - Manual

Assembly & Installation Instructions
A111
For Trestle Four-Light Pendant 13-2200 Page 1 of 4
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 19830
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
Stem Assembly (Figure 1)
Component Parts
A Fixture Pipe
B Fixture Coupling
1. Carefully unpack the fixture from the carton.
2. Carefully thread fixture pipe (A), threaded end first, over fixture
wires.
3. Apply a drop of the supplied thread locking compound to the internal
threads at the top of the fixture coupling (B) and screw stem into
fixture, being careful not to twist the wires.
Note: Application of the thread locking compound is necessary to
prevent the stem from loosening during regular maintenance and
cleaning of the fixture. Be certain to apply the compound.
4. See instructions below to complete the installation.
(Figure 1)
To Complete Assembly (Figures 2 & 3)
Component Parts
A Fixture Pipe
C Hex Head Nipple
D Crossbar
E Threaded
Stud
F Canopy
G Knurl
Ball
H Canopy Pipe
I Plastic Clutch Sleeve
J Clutch
K Set Screw (2)
Caution: Be sure power is off at the main breaker box prior to installation.
1. Thread the wires from the fixture pipe (A) into and
through the canopy pipe (H) up through the canopy (F).
2. Unscrew the clutch (J) from the canopy pipe (H); slide it
across the wires and onto the fixture pipe (A). Follow this
with the plastic clutch sleeve (I), oriented so the tapered
end of the clutch sleeve nests in the clutch.
3. Slide the canopy pipe (H) as far as necessary to give you
the total length of the fixture which you desire. Be careful
not to scratch the pipe surfaces and to pull excess wire up
through the canopy pipe (H). Screw clutch (J) onto canopy
pipe (H). There must be a minimum 1-1/2" of inner pipe
inside the outer pipe. Hand-tighten the clutch to
temporarily hold this adjustment. The clutch is not securely
fastened at this point; do not depend on it to hold the fixture.
Important: To ensure full connection strength, be sure the tapered end of the plastic clutch sleeve is oriented
toward the clutch when assembled and securely tighten set screw (Figure 2).
(Figure 2)
(continued)