Hubbardton Forge 133305 - Manual

Assembly & Installation Instructions
A248
Kirigami Four-Light Pendant 13-3305 Page 1 of 4
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 24618 Rev A
Prepare the Canopy (Figure 1)
Component Parts
A Jam Nut
B Crossbar
C Threaded
Nipple
D Canopy
E Canopy
Ring
F Coupling
G Canopy
Pipe
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Thread jam nut (A) and crossbar (B) onto threaded nipple (C) leave parts loose.
3. Using two machine screws (not provided), temporarily fasten the crossbar (B)
to the electric box.
Note: A new electric box comes with screws. When replacing a fixture, retain
the existing screws for use with the new fixture.
4. Adjust the length of threaded nipple (C) in crossbar (B) so that canopy ring (E)
will hold canopy (D) against the ceiling with no threads showing for best
appearance. When the correct adjustment is established, tighten jam nut (A)
against crossbar (B) to hold the adjustment.
5. Remove the crossbar and stem from the electrical box and proceed with the
assembly instructions.
To Complete Assembly & Install (Figures 2 & 3)
Component Parts
A Jam Nut
B Crossbar
C Threaded
Nipple
D Canopy
E Canopy
Ring
G Canopy Pipe
H Fixture Pipe
I Plastic Clutch Sleeve
J Clutch
K Set
Screw
1. Thread wires from the fixture pipe (H) through the canopy
pipe (G).
2. Unscrew the clutch (J) from the canopy pipe (G); slide it across the
wires and onto the fixture pipe (H). Follow this with the plastic
clutch sleeve (I), oriented so the tapered end of the clutch sleeve
nests in the clutch (Figure 2).
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Figure 2)