Hubbardton Forge 133360 - Manual

Assembly & Installation Instructions
A309
Icarus Triple Canopy Pendant 13-3360 Page 1 of 4
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 27236A
To Assemble Canopy (Figure 1)
Component Parts
A Hex Nipple (3)
B Lock Washer (3)
C Canopy
D Canopy Pipe (3)
1. Carefully unpack canopy from carton.
2. Line up end of canopy pipe (D) with hole in canopy (C).
3. Place hex nipple (A) through lock washer (B), down through holes in canopy and
thread into canopy pipe. Tighten securely.
4. Repeat steps 2 and 3 for the remaining stems.
Stem Assembly (Figure 2)
Component Parts
E Fixture Pipe (3)
F Fixture Coupling (3)
1. Carefully unpack the fixture from the carton.
2. Carefully thread fixture pipe (E), threaded end first, over fixture wires.
3. Apply a drop of the supplied thread locking compound to the internal threads of
fixture coupling (F) and screw stem into fixture, being careful not to twist or pinch the
wires.
Note: Application of the thread locking compound is necessary to prevent the stem
from loosening during regular maintenance and cleaning of the fixture. Be certain to
apply the compound.
4. Repeat for all three fixtures.
5. See instructions below to complete the installation.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Figure 2)