Hubbardton Forge 136405 - Manual

Installation Instructions
A243
For Axis Pendants 13-6405 & 13-6405F Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 24571
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
After installation extra hardware and accessories are possible; our kits are used on multiple products and options.
To Assemble Fixture (Figures 1 & 2)
Component Parts
A 8-32 Screw
B Canopy Pipe Assembly
C Cable Gripper Assembly
D Canopy
E Aircraft
Cable
F Cable Gripper
G Upper Assembly
Caution: Be sure power is off at the main breaker box prior to installation.
1. Remove 8-32 screw (A) and save for later use.
2. Lift cable gripper assembly (C) from canopy pipe assembly
(B) (Figure 2).
3. Slip wires and aircraft cable (E) through hole in the bottom of
canopy (D).
4. Slip canopy (D) onto upper assembly (G) and allow it to rest
on top of fixture.
5. Thread the wires and aircraft cable (E) from the upper
assembly (G) into and through the canopy pipe assembly (B).
6. Lower canopy pipe assembly (B) into upper assembly (G)
until it bottoms out.
7. Push the aircraft cable (E) through the bottom of the cable
gripper (F). Do not pull the aircraft cable completely through
at this point.
8. Slip canopy pipe assembly (B) up to desired height while
pulling the aircraft cable (E) through the cable gripper (F).
Measurement equals from ceiling to desired location of
fixture bottom subtract 6 3/16”. (If total length equals 40”
subtract 6 3/16” from 40” and this is the measurement to set
the canopy pipe assembly to).
9. Attach cable gripper assembly (C) to canopy pipe assembly
(B) using 8-32 screw (A).
10. Pull excess aircraft cable (E) through cable gripper (F) until
snug.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 2)
(Figure 1)