Hubbardton Forge 134505 - Manual

Assembly & Installation Instructions
A246
For Adjustable Mobius Shade Pendant 13-4505 Page 1 of 7
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 24615
Prepare the Canopy (Figure 1)
Component Parts
A Jam Nut
B Crossbar
C Threaded
Nipple
D Canopy
E Canopy
Ring
Caution: Be sure power is off at the main breaker box prior to installation.
1. Thread jam nut (A) and crossbar (B) onto threaded nipple (C); leave both parts
loose.
2. Using two machine screws (not provided), temporarily fasten the crossbar (B) to
the electric box. Note: A new electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture.
3. Adjust the length of threaded nipple (C) in crossbar (B) so that canopy ring (E)
will hold canopy (D) against the ceiling with no threads showing for best
appearance. When the correct adjustment is established, tighten jam nut (A)
against crossbar (B) to hold the adjustment.
4. Remove the crossbar and stem from the electrical box and proceed with the
assembly instructions.
Complete Assembly & Install Fixture (Figures 2 & 3)
Component Parts
D Canopy
E Canopy
Ring
F Canopy Pipe
G Fixture Pipe
H Plastic Sleeve
I Clutch
J Set
Screw
K Ground Screw
L Shade Spider
M Retaining Ring
N Socket
Caution: Be sure power is off at the main breaker box prior to installation.
1. Place canopy (D) over canopy pipe (F), followed by canopy ring (E). Make sure smaller diameter side of canopy
ring is oriented up toward the canopy.
2. Thread wires from the fixture pipe (G) through the canopy pipe (F).
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Figure 2)