Hubbardton Forge 137475 - Manual

Assembly & Installation Instructions
A146
Lyra Pendant 13-7470, 13-7470F, 137475 & 137475F Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 21178 Rev C
Prepare the Canopy (Figure 1)
Component Parts
A Jam Nut (2)
B Crossbar
C Threaded Nipple
D Canopy
E Canopy Ring
Caution: Be sure power is off at the main breaker box prior to installation.
1. Thread jam nuts (A) and crossbar (B) onto threaded nipple (C); leave parts loose.
2. Using two machine screws (not provided), temporarily fasten the crossbar (B) to
the electric box. Note: A new electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture.
3. Adjust the length of threaded nipple (C) in crossbar (B) so that canopy ring (E)
will hold canopy (D) against the ceiling with no threads showing for best
appearance. When the correct adjustment is established, tighten jam nuts (A)
against crossbar (B) to hold the adjustment.
4. Remove the crossbar and stem from the electrical box and proceed with the
assembly instructions.
Complete Assembly and Install (Figures 2 & 3)
Component Parts
D Canopy
E Canopy Ring F Canopy Pipe
G Plastic Sleeve H Clutch
I
Set Screw
J Fixture Pipe
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Place canopy (D) over canopy pipe (F), followed by canopy
ring (E). Make sure smaller diameter side of canopy ring is
oriented up toward the canopy.
2. Thread wires from the fixture pipe (J) through the canopy
pipe (F).
3. Unscrew the clutch (H) from the canopy pipe (F); slide it
across the wires and onto the fixture pipe (J). Follow this
with the plastic clutch sleeve (G), oriented so the tapered end
of the clutch sleeve nests in the clutch (Figure 2).
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 2)
(Figure 1)