Hubbardton Forge 137725 - Manual

Assembly & Installation Instructions
A313
Erlenmeyer Pendant 137725 Page 1 of 4
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 27331
Assemble Canopy (Figure 1)
Component Parts
A Canopy
B Canopy Pipe
C Hex Nipple (5)
D Lock Washer (5)
1. Carefully unpack the fixture from the carton.
2. Insert threaded end of hex nipple (C) down through lock washer (D) and into swivel end of canopy pipe (B).
3. Tighten securely being sure the notches in the swivels are aligned (see swivel detail).
Note: If installing on a sloped ceiling, make certain that the notches in the swivel portion of the stems are oriented
toward the lowers side of the slope.
4. Repeat steps for all five stems.
5. Continue with attaching fixture pipes
below.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)