Hubbardton Forge 137805 - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2014 Hubbardton Forge ® . All rights reserved. 30714
Assembly & Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Note: After installation extra hardware and accessories are possible due
to our kits are used on multiple products and options.
To Attach Fixture Pipes (Figure 1)
Component Parts
A Fixture Pipe
B Fixture Coupling
1. Carefully unpack the fixture from the carton.
2. Carefully thread fixture pipe (A), non-painted threaded end
first, over fixture wires.
3. Apply a drop of the supplied thread locking compound to
the internal threads at the top of the fixture coupling (B) and
screw stem into coupling (B), being careful not to
twist the wires.
Note: Application of the thread locking compound is necessary to
prevent the stem from loosening during regular maintenance and
cleaning of the fixture. Be certain to apply the compound.
To Assemble Canopy Pipes to Ceiling Bracket (Figure 2)
Component Parts
C Hex Nipple (2)
D Lock Washer (2)
E Ceiling Bracket
F Canopy Pipes (2)
1. Insert threaded end of hex nipple (C) down through lock
washer (D), ceiling bracket (E) and into swivel at the end of
canopy pipe (F). Note: Ceiling bracket oriented with
threaded studs pointing downward.
2. Tighten hex nipples (C) securely being sure the notches in
the swivels are aligned.
Note: If installing on a sloped ceiling, make certain that the notches
in the swivel portion of the stems are oriented toward the lower side
of the slope.
A361
Pluto 5lt Pendant 137805 Page 1 of 4
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Continued)
(Figure 2)
F
C
E
D
B
A
NOTCH IN SWIVEL