Hubbardton Forge 137901 - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2014 Hubbardton Forge ® . All rights reserved. 30715 Rev B
Assembly & Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
To Attach Fixture Pipes (Figures 1 & 2)
Component Parts
A Anchor (4)
B Mounting Bracket
C #10 Screw
D Threaded stud (2)
E Cupped washer
F Ground Screw
G Gripper
H Support Cable (2)
I Canopy
J #8 Screws (2)
K Knurled Ball (2)
L Fixture
M Transformer
N Gripper Locks (2)
O Black Isolation Sleeve (2)
1. Carefully unpack the fixture from the carton.
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
2. Position the mounting bracket (B) over the electrical box
aligning ovals in bracket with mounting holes in electrical
box. Orient mounting bracket to desired hanging position
and mark the location of the anchors (A) on the ceiling. Set
the mounting bracket aside.
3. Drill 1/8” holes in the location marked on the ceiling. Place
the tapered ends of the anchors (A) into the holes and gently
tap flush using a lightweight hammer.
4. Place mounting bracket (B) over electrical box. Lining up
holes in bracket with the anchors installed in the ceiling.
Using two machine screws (not provided) fasten the mount-
ing bracket (B) to the electric box.
Note: A new electric box comes with screws. When replacing an
existing fixture, retain screws for use with the new fixture.
5. Thread the #10 screws (C) through the bracket and into the
anchors (A) to secure the bracket to the ceiling. Be careful
not to over tighten or strip the anchors.
A362
For Aperture Pendant 137901 Page 1 of 4
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Continued)
B
A
G
N
C
M
D