Hubbardton Forge 138585 - Manual

Assembly & Installation Instructions
A257
For Aura Pendant 13-8585 Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 24787
To Install to Ceiling (Figures 1 thru 6)
Component Part
A Ceiling Bracket
B Lag Screw (4)
C Hex
Nut
D Canopy
E Strain
Relief
F Support Cable (3)
G Cable Gripper (3)
H Strain Relief Cap
I Supply wire
J Flat Head Screws (2)
K Threaded Standoffs (2)
L Cupped
Washer
M Ground Screw
N Canopy Nipple
O Canopy Cover
P Lock
Up
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Carefully unpack the fixture from the carton.
2. Put the ceiling bracket (A) and canopy (D) together, making sure
the canopy mounting holes match up with the ceiling bracket
threaded standoffs. Orient them to achieve desired wire location.
Note: Canopy and ceiling bracket only install one direction which
determines where the wire entry location through the canopy
will be.
3. Using the four lag screws (B) attach ceiling bracket (A) to a
structural member in the ceiling, centering the
crossbar over the outlet box. We've supplied lag
screws with your fixture; however, different
materials and/or construction methods may
require different fasteners. If in doubt, contact a
qualified electrician. Do not attach crossbar
directly to outlet box.
4. Install strain relief (E) into canopy (D). Thread
hex nut (C) onto strain relief and tighten
(Figure 2). Do not over-tighten.
5. Raise fixture and push support cable (F) next to
the strain relief (E) through cable gripper (G).
Slip canopy (D) onto the cable oriented so the
strain reliefs are above each other.
6. Slip the other two support cables (F) through the
canopy (D) and into the cable grippers (G) until
desired fixture height is accomplished and level.
7. Slip supply wire (I) through the strain relief cap
(H) and through the strain relief (E).
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Figure 3)
(Figure 2)