Hubbardton Forge 139600 - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved. 19406 Rev B
Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
To Assemble Fixture (Please see Figure 1 and illustrations on Page 3)
Component Parts
A Shade
B Retaining screws
C Spider assembly
D Support arms
E Socket assembly
F Diffuser
G Threaded Coupling
H Fixture pipe
I Clutch
J Clutch sleeve
K Canopy pipe
L Barrel knobs
M Canopy
N Threaded studs
O Crossbar
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR
TO INSTALLATION.
1. Carefully unpack the fixture from the carton.
2. Thread the wires from the fixture pipe (H) into and through
the canopy pipe (K) and up through the canopy (M). Unscrew
the clutch (I) from the canopy pipe (K); slide it across the wires
and onto the fixture pipe (H). Follow this with the clutch sleeve
(J), so that the clutch sleeve nests in the clutch.
Important: To ensure full connection strength, make sure the tapered
end of the plastic clutch sleeve is oriented toward the clutch (Figure
1).
Slide the smaller pipe as far as necessary to give you the total length
of the fixture which you desire. Be careful not to scratch the pipe
surfaces and to pull excess wire up through the canopy. There must
be a minimum 1-1/2" of inner pipe inside the outer pipe. Hand-tight
en the clutch to temporarily hold this adjustment. At this
point the adjustment is not securely fastened; do not depend on it to
permanently hold the fixture.
A94
For Exos Shade Pendant 139600 & 139600F Page 1 of 3
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Continued)
CLUTCH
TAPPERED END
OF PLASTIC SLEEVE