Hubbardton Forge 139635 - Manual (Page 2)

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved.
28093A
Assembly & Installation Instructions
To Complete Assembly & Install (Figures 2 & 3)
Component Parts
A Jam Nut
B Crossbar
C Threaded Nipple
D Canopy
E Canopy Ring
1. Slide canopy ring (E) with smaller diameter facing up fol-
lowed by canopy (D) over fixture pipe (H) and gently rest
against the socket washer (R).
2. Thread wires from the fixture pipe (H) through the canopy
pipe (G).
3. Unscrew the clutch (J) from the canopy pipe (G); slide it
across the wires and onto the fixture pipe (H). Follow this
with the plastic clutch sleeve (I) as seen in Figure 3. Orient
clutch sleeve so the tapered end nests in the clutch (Figure
2).
4. Slide the canopy pipe (G) as far as necessary to give you
the total length of the fixture which you desire. Be careful
not to scratch the pipe surfaces and to pull excess wire
up through the canopy pipe (G). There must be a minimum
1-1/2" of inner pipe inside the outer pipe. Screw clutch (J)
onto canopy pipe and hand-tighten the clutch to temporar-
ily hold this adjustment. The clutch is not securely fastened
at this point; do not depend on it to hold the fixture.
Note: To ensure full connection strength, be sure the tapered end
of the plastic clutch sleeve is oriented toward the clutch when
assembled and securely tighten set screw (Figure 2).
5. Using two machine screws (not provided), fasten the cross-
bar (B) to the electric box.
Note: A new electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture.
6. Using suitable wire connectors (not provided), connect
fixture wires to supply wires (white to white or ribbed side
of the fixture cord, black to black or smooth side, and bare
copper to bare copper or green supply). Push wires back
into outlet box.
CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON
SECURELY, AND NO BARE WIRE IS EXPOSED.
A322
Exos Square Shade Pendant 139625, 139630 & 139635 Page 2 of 4
(Figure 2)
G Canopy Pipe
H Fixture Pipe
I Plastic Clutch Sleeve
J Clutch
K Set Screw
(Continued)
I
(Figure 3)
C
B
A
D
E
G
I
J
K
H
LARGE DIAMETER PIPE
CLUTCH
PLASTIC CLUTCH SLEEVE