Hubbardton Forge 18352 - Manual

Assembly & Installation Instructions
A60
For Adjustable Pendant Model 18-332 & 18-352 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 16520 Rev C
To Complete Fixture Assembly (Figures 1 & 2)
Component Parts
A Fixture Pipe
B Canopy Pipe
C Canopy
D Crossbar
E Ground
Screw
F Threaded Stud (2)
G Knurl Balls (2)
H Plastic Clutch Sleeve
I Clutch
J Set
Screw
K Locking Nut
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Thread the wires from the fixture pipe (A) into and through the canopy pipe (B) up
through the canopy (C).
3. Unscrew the clutch (I) from the canopy pipe (B); slide it across the wires and onto
the fixture pipe (A). Follow this with the plastic clutch sleeve (H), oriented so the
tapered end of the clutch sleeve nests in the clutch.
4. Slide the smaller pipe as far as necessary to give you the total length of the fixture
which you desire. Be careful not to scratch the pipe surfaces and to pull excess wire
up through the canopy. There must be a minimum 1-1/2" of inner pipe inside
the outer pipe. There must be a minimum of 6-1/2" between the clutch and the
locking nut to allow for bulb replacement. Hand-tighten the clutch to
temporarily hold this adjustment. At this point the adjustment is not securely
fastened; do not depend on it to permanently hold the fixture.
Important: To ensure full connection strength, be sure the tapered end of the
plastic clutch sleeve is oriented toward the clutch when assembled and securely
tighten set screw (Figure 2).
5. Thread studs (F) through appropriate holes in crossbar (D) to match holes in
canopy (C).
6. Using two machine screws (not provided), fasten the crossbar (C) to the electric
box.
Note: A new electric box comes with screws. When replacing a fixture, retain the
existing screws for use with the new fixture.
7. Using suitable wire connectors (not provided) connect fixture wires to supply
(white to white or ribbed and black to black or smooth). Connect all ground wires
to green ground screw (E).
Caution: Make sure wire connectors are twisted on securely, and no bare wire is
exposed.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
This illustration represents a typical
fixture and may not match every style.