Hubbardton Forge 18303 - Manual

Assembly & Installation Instructions
A239
For Flora Adjustable Pendant 18-303 Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 24412
Prepare the Canopy (Figure 1)
Component Parts
C Jam Nut (2)
D Crossbar
E Threaded
Nipple
F Canopy
G Canopy
Ring
Caution: Be sure power is off at the main breaker box prior to installation.
1. Thread jam nuts (C) and crossbar (D) onto threaded nipple (E); leave parts loose.
Note: Fixture comes with two jam nuts but in most cases only one is needed.
2. Using two machine screws (not provided), temporarily fasten the crossbar (D) to the
electric box.
Note: A new electric box comes with screws. When replacing a fixture, retain the
existing screws for use with the new fixture.
3. Adjust the length of threaded nipple (E) in crossbar (D) so that canopy ring (G) will
hold canopy (F) against the ceiling with no threads showing for best appearance.
When the correct adjustment is established, tighten jam nut (C) against crossbar (D)
to hold the adjustment.
4. Remove the crossbar and stem from the electrical box and proceed with the assembly
instructions.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)