Hubbardton Forge 18715 - Manual

Assembly & Installation Instructions
A275
Erlenmeyer Pendant 18-710 Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 26491
To Assemble Fixture (Figures 1 & 2)
Component Parts
A Fixture pipe
B Canopy
C Canopy pipe D Clutch sleeve
E Clutch
F Set Screw
1. Carefully unpack the fixture from the carton.
2. Slip the wires from the fixture pipe (A) into and through the canopy pipe (C)
up through the canopy (B).
3. Unscrew the clutch (E) from the canopy pipe (C); slide it across the wires and
onto the fixture pipe (A). Follow this with the plastic clutch sleeve (D),
oriented so the tapered end of the clutch sleeve nests in the clutch (Figure 2).
4. Slide the canopy pipe (C) as far as necessary to give you the total length of
the fixture which you desire. Be careful not to scratch the pipe surfaces and to
pull excess wire up through the canopy pipe (C). Screw clutch (E) onto
canopy pipe (C). There must be a minimum 1-1/2" of inner pipe inside the
outer pipe. Hand-tighten the clutch to temporarily hold this adjustment. The
clutch is not securely fastened at this point; do not depend on it to hold the
fixture.
Important: To ensure full connection strength, be sure the tapered end of the
plastic clutch sleeve is oriented toward the clutch when assembled and
securely tighten set screw (Figure 2).
5. Stop. Please see installation instructions on next page.
6. Once the fixture is fastened to the ceiling, tighten the set screw (F) firmly
with hex wrench provided. Only after the set screw (F) is tight should you
install the glass.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Figure 2)
(Figure 1)