Hubbardton Forge 18730 - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved. 28299 A
Assembly & Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Please Note: After installation, extra hardware and accessories are
possible; our kits are used on multiple products and options.
To Complete Fixture Assembly (Figures 1 & 2)
Component Parts
A Fixture Pipe
B Canopy
C Crossbar
D Ground Screw
E Threaded Stud (2)
F Barrel Knob (2)
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
1. Thread the wires from the fixture pipe (A) into and through
the fixture bar (S), canopy pipe (G) up through the
canopy (B).
2. Unscrew the clutch (I) from the canopy pipe (G); slide it
across the wires and onto the fixture pipe (A). Follow
this with the plastic clutch sleeve (H), oriented so the
tapered end of the clutch sleeve nests in the clutch.
3. Slide the canopy pipe (G) as far as necessary to give you
the total length of the fixture which you desire. Be careful not
to scratch the pipe surfaces. Pull excess wire up
through the canopy pipe (G). Screw clutch (I) onto canopy
pipe (G). There must be a minimum 1-1/2" of inner
pipe inside the outer pipe. Hand-tighten the clutch
to temporarily hold this adjustment. The clutch is not
securely fastened at this point; do not depend on it
to hold the fixture.
Important: To ensure full connection strength, be sure the tapered
end of the plastic clutch sleeve is oriented toward the clutch when
assembled and securely tighten set screw (Figure 2).
4. Thread studs (E) through appropriate holes in crossbar (C) to
match holes in canopy (B).
A331
Cuff Pendant 18730 & 18733 Page 1 of 3
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Continued)
G Canopy Pipe
H Plastic Clutch Sleeve
I Clutch
J Set Screw
S Fixture Bar
C
A
B
D
E
G
H
F
J
I
S