Hubbardton Forge 18761 - Manual

Assembly & Installation Instructions
A214
Antimeny Single Pendant 18-761 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 22863
Please Note: After installation extra hardware and accessories are possible due to our kits are used on multiple products
and options.
To Complete Fixture Assembly (Figures 1 & 2)
Component Parts
A Fixture Pipe
B Canopy
C Crossbar
D Ground
Screw
E Threaded Stud (2)
F Barrel Knob (2)
G Canopy Pipe (2)
H Plastic Clutch Sleeve (2)
I Clutch
(2)
J Set Screw (2)
Caution: Be sure power is off at the main breaker box prior to installation.
1. Thread the wires from the fixture pipe (A) into and through the canopy pipe (G) up through
the canopy (B).
2. Unscrew the clutch (I) from the canopy pipe (G); slide it across the wires and onto the
fixture pipe (A). Follow this with the plastic clutch sleeve (H), oriented so the tapered end of
the clutch sleeve nests in the clutch.
3. Slide the canopy pipe (G) as far as necessary to give you the total length of the fixture which
you desire. Be careful not to scratch the pipe surfaces and to pull excess wire up through the
canopy pipe (G). Screw clutch (I) onto canopy pipe (G). There must be a minimum 1-1/2"
of inner pipe inside the outer pipe. Hand-tighten the clutch to temporarily hold this
adjustment. The clutch is not securely fastened at this point; do not depend on it to hold the
fixture. Important: To ensure full connection strength, be sure the tapered end of the plastic
clutch sleeve is oriented toward the clutch when assembled and securely tighten set screw
(Figure 2).
4. Thread studs (E) through appropriate holes in crossbar (C) to match holes in canopy (B).
5. Using two machine screws (not provided), fasten the crossbar (C) to the electric box.
Note: A new electric box comes with screws. When replacing a fixture, retain the existing
screws for use with the new fixture.
6. Using suitable wire connectors (not provided) connect fixture
wires to supply (white to white or ribbed and black to black or
smooth). Connect all ground wires to green ground screw (D).
Caution: Make sure wire connectors are twisted on securely,
and no bare wire is exposed.
7. Slide canopy (B) over threaded studs (E) and push firmly to
ceiling, making sure that no wires are pinched between fixture
canopy and ceiling. Fasten with barrel knobs (F). Be sure studs
are fully seated in the barrel knobs.
8. Once the fixture is fastened to the ceiling, tighten the set screw
(J) in clutch (I) firmly with hex wrench provided. Only after the
set screw (J) is tight should you install the glass.
9. Refer instructions following to install glass. (continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Figure 2)